Enabling Dhcp Relay; Binding An Interface To A Dhcp Server Group - Huawei Quidway S9300 Configuration Manual
Terabit routing switch v100r001c03
Hide thumbs
Also See for Quidway S9300:
- Configuration manual - network management (630 pages) ,
- Configuration manual (603 pages) ,
- Configuration manual - multicast (262 pages)
Table of Contents
Advertisement
2 DHCP Configuration
2.3.3 Enabling DHCP Relay
Context
Do as follows on the S9300.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface vlanif vlan-id
The VLANIF interface view is displayed.
Step 3 Run:
dhcp select relay
DHCP relay is enabled on the VLANIF interface.
----End
2.3.4 Binding an Interface to a DHCP Server Group
Context
Do as follows on the S9300.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface vlanif vlan-id
The VLANIF interface view is displayed.
Step 3 Run:
ip address ip-address { mask | mask-length }
The IP address is assigned to the VLANIF interface.
Step 4 Run:
dhcp select relay
You can enable the DHCP relay function.
2-4
NOTE
The number of DHCP relay agents between a server and a client must be no more than 4; otherwise, DHCP
messages are discarded.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Quidway S9300 Terabit Routing Switch
Configuration Guide - IP Service
Issue 02 (2009-08-06)
Advertisement
Table of Contents
