Configuring G.shdsl Interface Binding - Huawei AR1200 series Configuration Manual

Huawei AR1200 Series Enterprise Routers
Configuration Guide - Interface Management
Step 3 Run:
shutdown
The G.SHDSL interface is deactivated.
----End

14.4.3 Configuring G.SHDSL Interface Binding

You can bind G.SHDSL interfaces to increase the link bandwidth.
Prerequisites
The G.SHDSL interface has been deactivated.
Context
A 4G.SHDSL board on the AR1200 has only one physical interface. This physical interface can
be virtualized into four G.SHDSL interfaces numbered from 0 to 3.
The AR1200 must be configured with the same interface binding mode as the DSLAM. For
example, if the DSLAM is configured with binding between interfaces 1 and 2, the AR1200
must also be configured with binding between interfaces 1 and 2. When binding interfaces, the
following requirements apply:
l
l
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run either of the following commands to enter the G.SHDSL interface view.
l
l
Step 3 Run:
shdsl bind { efm | m-pair } link_number
The binding mode is set for the G.SHDSL interface.
Issue 01 (2012-04-20)
interface ethernet interface-number
Only contiguous interfaces on the same 4G.SHDSL board can be bound together. The
number of the first interface to be bound must be 0 or 2. The first bound interface is the
main interface, and the remaining bound interfaces are slave interfaces.
Before binding, interfaces must be deactivated and not configured with any service.
If the working mode is set to ATM, run:
interface atm interface-number
If the working mode is set to ATM, run:
interface ethernet interface-number
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
14 G.SHDSL Interface Configuration
140