Table 29: Snmp Commands - Edge-Core ECS4120-28F Reference Manual

5
SNMP Commands
SNMP commands control access to this switch from management stations using
the Simple Network Management Protocol (SNMP), as well as the error types sent
to trap managers.
SNMP Version 3 also provides security features that cover message integrity,
authentication, and encryption; as well as controlling user access to specific areas
of the MIB tree. To use SNMPv3, first set an SNMP engine ID (or accept the default),
specify read and write access views for the MIB tree, configure SNMP user groups
with the required security model (i.e., SNMP v1, v2c or v3) and security level (i.e.,
authentication and privacy), and then assign SNMP users to these groups, along
with their specific authentication and privacy passwords.

Table 29: SNMP Commands

Command
General SNMP Commands
snmp-server
snmp-server community
snmp-server contact
snmp-server location
show snmp
SNMP Target Host Commands
snmp-server enable traps
snmp-server host
snmp-server
enable port-traps
mac-notification
show snmp-server enable
port-traps
SNMPv3 Commands
snmp-server engine-id
snmp-server group
snmp-server user
snmp-server view
show snmp engine-id
show snmp group
Function
Enables the SNMP agent
Sets up the community access string to permit access to
SNMP commands
Sets the system contact string
Sets the system location string
Displays the status of SNMP communications
Enables the device to send SNMP traps (i.e., SNMP
notifications)
Specifies the recipient of an SNMP notification operation
Enables the device to send SNMP traps (i.e., SNMP
notifications) when a dynamic MAC address is added or
removed
Shows if SNMP traps are enabled or disabled for the
specified interfaces
Sets the SNMP engine ID
Adds an SNMP group, mapping users to views
Adds a user to an SNMP group
Adds an SNMP view
Shows the SNMP engine ID
Shows the SNMP groups
– 177 –
Mode
GC
GC
GC
GC
NE, PE
GC
GC
IC
PE
GC
GC
GC
GC
PE
PE