Alcatel-Lucent 7750 SR OS Service Manual page 369

Table 1: CLI Commands to Configure VPLS Service Parameters (Continued)
Command
mst-instance
mst-path-cost
mst-port-priority
path-cost
port-num
priority
root-guard
no shutdown
Configure SAP subscriber management parameters
config>service>vpls>sap>sub-sla-mgmt
def-sla-profile
def-sub-profile
mac-da-hashing
multi-sub-sap
single-sub-parameters
non-sub-traffic
profiled-traffic-only
sub-ident-policy
no shutdown
Configure mesh SDP parameters
config>service>vpls# mesh-sdp sdp-id[:vc-id] [vc-type {ether|vlan}]
accounting-policy
7750 SR OS Services Guide
Enables the context to configure MSTI related parameters at SAP level.
Specifies path-cost within a given instance, expressing probability that
given port will be put into forwarding state in case loop occurs.
Specifies the port priority within a given instance, expressing
probability that given port will be put into a forwarding state if loop
occurs.
Configures the Spanning Tree Protocol (STP) path cost for the SAP.
These are the values used for CIST when running MSTP.
Configures the virtual port number which uniquely identifies a SAP
within configuration bridge protocol data units (BPDUs).
Configures the Spanning Tree Protocol (STP) priority for the SAP.
These are the values used for CIST when running MSTP.
Specifies whether this port is allowed to become an STP root port.
Administratively enables an entity.
Specifies a default SLA profile for this SAP. The SLA profile must be
defined prior to associating the profile with a SAP in the
config>subscriber-mgmt>sla-profile context.
Specifies a default subscriber profile for this SAP. The subscriber
profile must be defined prior to associating the profile with a SAP in the
config>subscriber-mgmt>sub-profile context.
Specifies whether subscriber traffic egressing a LAG SAP has its egress
LAG link selected by a function of the MAC destination address instead
of the subscriber ID.
Configures the maximum number of subscribers for this SAP.
Enables enables the context to configure single subscriber parameters
for this SAP.
Configures non-subscriber traffic profiles.
Enables profiled traffic only for this SAP.
Associates a subscriber identification policy to this SAP. The subscriber
identification policy must be defined prior to associating the profile
with a SAP in the config>subscriber-mgmt>sub-ident-policy context.
Administratively enables an entity.
Configures the accounting policy that applies to the SDP.
Virtual Private LAN Services
Description Page
486
486
486
490
490
491
529
457
530
530
531
531
532
531
532
533
457
522
Page 369