Alcatel-Lucent 7750 SR OS Service Manual page 363

Table 1: CLI Commands to Configure VPLS Service Parameters (Continued)
Command
def-mesh-vc-id
description
disable-aging
disable-learning
discard-unknown
fdb-table-high-wmark
fdb-table-low-wmark
fdb-table-size
local-age
mac-move
mac-protect
move-frequency
retry-timeout
remote-age
send-flush-on-failure
service-mtu
no shutdown
Configure VPLS STP parameters
config>service# vpls
stp
forward-delay
hello-time
hold-count
max-age
mst-instance
mst-priority
7750 SR OS Services Guide
Configures the value used by each end of a tunnel to identify the VC.
A text string describing the service.
Disables MAC address aging across a VPLS service.
Disables MAC address learning across a VPLS service.
Discards unknown destination addresses.
Specifies the value to send logs and traps when the threshold is reached.
Configures the low watermark for the FDB table.
Specifies the maximum number of MAC entries in the forwarding
database (FDB).
Specifies the aging time for locally learned MAC addresses in the FDB.
Enables the context to configure MAC move attributes.
Indicates whether or not this MAC is protected.
Indicates the maximum rate at which MAC's can be re-learned in the
VPLS service, before the SAP where the moving MAC was last seen is
automatically disabled in order to protect the system against undetected
loops or duplicate MAC's.
Indicates the time in seconds to wait before a SAP that has been
disabled after exceeding the maximum relearn rate is re-enabled.
Specifies the aging time for remotely learned MAC addresses in the
FDB.
Enables sending MAC withdraw message on SAP/spoke-SDP failure.
Configures the service payload (Maximum Transmission Unit – MTU)
in bytes for the service ID overriding the service-type default MTU.
Administratively enables the service.
Context for configuring the STP bridge-level parameters for the VPLS
instance.
Configures STP forward delay timer for the VPLS instance.
Configures STP hello time for the VPLS instance.
Configure BPDU transmit hold count.
Configures STP max age for the VPLS instance.
Creates the context to configure MST instance (MSTI) related
parameters.
Specifies the bridge priority for this specific Multiple Spanning Tree
instance for this service.
Virtual Private LAN Services
Description Page
460
458
461
461
462
462
462
462
466
466
467
468
468
469
470
470
457
483
484
484
485
487
487
488
Page 363