Alcatel-Lucent 7750 SR OS Service Manual page 368

Configuring a VPLS Service with CLI
Table 1: CLI Commands to Configure VPLS Service Parameters (Continued)
Command
scheduler-override
scheduler-policy
Configure SAP ingress parameters
config>service>vpls>sap#
ingress
filter
match-qinq-dot1p
qos
queue-override
queue
adaptation-rule
cbs
high-prio-only
mbs
rate
scheduler-override
scheduler-policy
scheduler-policy
Configure SAP STP parameters
config>service>vpls>sap>stp#
auto-edge
edge-port
link-type
Page 368
Specifies the set of attributes whose values have been overridden via
management on this virtual scheduler.
Associates an existing scheduler policy to an egress scheduler used by
SAP queues associated with this multi-service customer site.
Configures ingress SAP QoS policies and filter policies.
Associates an IP filter policy or MAC filter policy with an ingress SAP
or IP interface.
Configures filtering based on the p-bits in the top or bottom tag of a Q-
in-Q encapsulated Ethernet frame.
Associates a Quality of Service (QoS) policy with an ingress SAP or IP
interface.
Enables the context to configure override values for the specified SAP
egress QoS queue.
Specifies the ID of the queue whose parameters are to be overridden.
Overrides specific attributes of the specified queue's adaptation rule
parameters.
Overrides specific attributes of the specified queue's CBS parameters.
Overrides specific attributes of the specified queue's high-prio-only
parameters.
Overrides specific attributes of the specified queue's MBS parameters.
Overrides specific attributes of the specified queue's Peak Information
Rate (PIR) and the Committed Information Rate (CIR) parameters.
Specifies the set of attributes whose values have been overridden via
management on this virtual scheduler.
Associates an existing scheduler policy to an egress scheduler used by
SAP queues associated with this multi-service customer site.
Associates an existing scheduler policy to an ingress scheduler used by
SAP queues associated with this multi-service customer site.
Configures automatic detection of the edge port characteristics of the
SAP or spoke SDP.
Configures the SAP as an edge or non-edge port.
Instructs STP on the maximum number of bridges behind this SAP.
Description
7750 SR OS Services Guide
Page
515
517
504
505
518
507
508
508
509
511
512
513
514
515
517
517
483
483
485