Alcatel-Lucent 7750 SR OS Service Manual page 239

revert-time
Syntax revert-time [revert-time | infinite]
no revert-time
Context config>service>apipe>endpoint
config>service>epipe>endpoint
config>service>fpipe>endpoint
config>service>ipipe>endpoint
Description
This command configures the time to wait before reverting back to the primary spoke SDP defined on
this service endpoint, after having failed over to a backup spoke SDP.
Parameters
revert-time — Specify the time, in seconds, to wait before reverting to the primary SDP.
infinite — Causes the endpoint to be non-revertive.
interworking
Syntax interworking {frf-5}
no interworking
Context
config>service>apipe
Description
This command specifies the interworking function that should be applied for packets that ingress/
egress SAPs that are part of an Apipe service.
Interworking is applicable only when the two endpoints (i.e., the two SAPs or the SAP and the spoke-
sdp) are of different types. Also, there are limitations on the combinations of SAP type, vc-type, and
interworking values as shown in
Table 1: Allowable Combinations of SAP Type, VC-type, and Interworking
Default
none (Interworking must be configured before adding a Frame-Relay SAP to an Apipe service.)
Parameters
frf-5 — Specify Frame Relay to ATM Network Interworking (FRF.5).
service-mtu
Syntax service-mtu octets
no service-mtu
7750 SR OS Services Guide
Values
0 — 600
SAP Type Allowed VC-Type Value
ATM VC atm-vcc, atm-sdu
fr-dlci
FR DLCI fr-dlci
atm-sdu
Table 5.
none
Not Supported
none
frf-5
Virtual Leased Line Services
Allowed Interworking Value
Page 239