Alcatel-Lucent 7750 SR OS Service Manual page 158

Configuring a VLL Service with CLI
Table 1: CLI Commands to Configure VLL Service Parameters (Continued)
Command
rate
scheduler-override
scheduler-policy
Configure Ipipe SAP ingress parameters
config>service>ipipe>sap#
ingress
filter
match-qinq-dot1p
qos
queue-override
queue
adaptation-rule
cbs
high-prio-only
mbs
rate
scheduler-override
scheduler-policy
Configure Ipipe spoke SDP parameters
config>service>ipipe# spoke-sdp sdp-id:vc-id [no-endpoint]
config>service>ipipe# spoke-sdp sdp-id:vc-id [endpoint endpoint-name] [icb]
ce-address
control-word
egress
ingress
Page 158
Specifies attributes of the Peak Information Rate (PIR) and the
Committed Information Rate (CIR) parameters.
Specifies attributes of the the set of attributes whose values have been
overridden via management on this virtual scheduler.
Associates an existing scheduler policy to an egress scheduler used by
SAP queues associated with this multi-service customer site.
Configures ingress SAP QoS policies and filter policies.
Associates an IP filter policy or MAC filter policy with an ingress
SAP or IP interface.
Configures filtering based on the p-bits in the top or bottom tag of a
Q-in-Q encapsulated Ethernet frame.
Associates a Quality of Service (QoS) policy with an ingress SAP or
IP interface.
Enables the context to configure override values for the specified SAP
egress QoS queue.
Specifies the ID of the queue whose parameters are to be overridden.
Specifies attributes of the queue's adaptation rule parameters.
Specifies attributes of the CBS parameters.
Specifies attributes of the high-prio-only parameters.
Specifies attributes of the MBS parameters.
Specifies attributes of the Peak Information Rate (PIR) and the
Committed Information Rate (CIR) parameters.
Specifies the set of attributes whose values have been overridden via
management on this virtual scheduler.
Associates an existing scheduler policy to an egress scheduler used by
SAP queues associated with this multi-service customer site.
Specifies the IP address of the CE device associated with an Ipipe
spoke SDP.
Specifies whether the use of the control word is preferred or not.
Configures the egress spoke SDP context.
Configures the ingress spoke SDP context.
Description
7750 SR OS Services Guide
Page
258
259
262
249
249
263
251
252
252
253
255
256
257
258
259
259
276
127
271
249