Alcatel-Lucent 7750 SR OS Service Manual page 170

Configuring a VLL Service with CLI
Distributed Epipe SAPs
To configure a distributed Epipe service, you must configure service entities on the originating
and far-end nodes. You must use the same service ID on both ends (for example, Epipe 5500 on
ALA-1 and Epipe 5500 on ALA-2). The
A distributed Epipe consists of two SAPs on different nodes.
By default, QoS policy ID 1 is applied to ingress and egress service SAPS. Existing filter policies
or other existing QoS policies can be associated with service SAPs on ingress and egress.
An existing scheduler policy can be applied to ingress and egress SAPs to be used by the SAP
queues. The schedulers comprising the policy are created at the time the scheduler policy is
applied to the SAP. If any orphaned queues (queues with a non-existent local scheduler defined)
exist on a SAP and the policy application creates the required scheduler, the status on the queue
becomes non-orphaned at this time.
Ingress and egress SAP parameters can be applied to local and distributed Epipe service SAPs.
For SDP configuration information, see
information, see
This example configures a distributed service between ALA-1 and ALA-2.
ALA-1>epipe 5500 customer 5 create
config>service>epipe$ description "Distributed epipe service to east coast"
config>service>epipe# sap 2/1/3:21 create
config>service>epipe>sap# ingress
config>service>epipe>sap>ingress# qos 555
config>service>epipe>sap>ingress# filter ip 1
config>service>epipe>sap>ingress# exit
config>service>epipe>sap# egress
config>service>epipe>sap>egress# qos 627
config>service>epipe>sap>egress# scheduler-policy alpha
config>service>epipe>sap>egress# exit
config>service>epipe>sap# no shutdown
config>service>epipe>sap# exit
config>service>epipe#
ALA-2>config>service# epipe 5500 customer 5 create
config>service>epipe$ description "Distributed epipe service to west coast"
config>service>epipe# sap 4/1/4:550 create
config>service>epipe>sap# ingress
config>service>epipe>sap>ingress# qos 654
config>service>epipe>sap>ingress# filter ip 1020
config>service>epipe>sap>ingress# exit
config>service>epipe>sap# egress
config>service>epipe>sap>egress# qos 432
config>service>epipe>sap>egress# filter ip 6
config>service>epipe>sap>egress# scheduler-policy test1
config>service>epipe>sap>egress# exit
config>service>epipe>sap# no shutdown
config>service>epipe#
The following example displays the SAP configurations for ALA-1 and ALA-2:
Page 170
Configuring SDP Bindings on page
spoke-sdp sdp-id:vc-id
Configuring an SDP on page
173.
7750 SR OS Services Guide
must match on both sides.
68. For SDP binding