Vll Sap Commands - Alcatel-Lucent 7750 SR OS Service Manual

Service router - mobile gateway
Hide thumbs Also See for 7750 SR OS:
Table of Contents

Advertisement

VLL SAP Commands

sap
Syntax
sap sap-id [no-endpoint] [create]
sap sap-id endpoint endpoint-name [create]
no sap sap-id
Context
config>service>epipe
config>service>apipe
config>service>fpipe
config>service>ipipe
Description
This command creates a Service Access Point (SAP) within a service. A SAP is a combination of port
and encapsulation parameters which identifies the service access point on the interface and within the
7750. Each SAP must be unique.
All SAPs must be explicitly created. If no SAPs are created within a service or on an IP interface, a
SAP will not exist on that object.
Enter an existing SAP without the create keyword to edit SAP parameters. The SAP is owned by the
service in which it was created.
A SAP can only be associated with a single service. A SAP can only be defined on a port that has
been configured as an access port using the config router interface port-type port-id mode access
command. Channelized TDM ports are always access ports.
If a port is shutdown, all SAPs on that port become operationally down. When a service is shutdown,
SAPs for the service are not displayed as operationally down although all traffic traversing the service
will be discarded. The operational state of a SAP is relative to the operational state of the port on
which the SAP is defined.
The following are supported:
7750 SR OS Services Guide
• ATM VPI/VCI on an ATM port for vc-type atm-vcc and atm-sdu
• ATM VPI on an ATM port for vc-type atm-vpc
• ATM virtual trunk - a range of VPIs on an ATM port for vc-type atm-cell
• ATM port for vc-type atm-cell
• Frame Relay DLCI on a port for vc-type atm-sdu
• ATM SAP carries the IPv4 packet using RFC 2684, VC-Mux or LLC/SNAP routed PDU encap-
sulation for Ipipe service
• Frame Relay SAP RFC 2427, routed PDU encapsulation for Ipipe service
• Ethernet SAP RFC 1332, PPP IPCP encapsulation of an IPv4 packet for Ipipe service
• Ethernet SAP HDLC SAP uses the routed IPv4 encapsulation for Ipipe service
• ATM - Frame Relay, PPP/IPCP - PPP/IPCP
• Frame Relay-Frame Relay, ATM - ATM
• Ethernet-Ethernet
• cHDLC-cHDLC
Virtual Leased Line Services
Page 241

Advertisement

Table of Contents
loading

Table of Contents