Alcatel-Lucent 7750 SR OS Service Manual page 103

7750 SR OS Services Guide
Label
SDP Id
Adm MTU
Opr MTU
IP address
Adm
Admin State
Opr
Oper State
Deliver
Flags
Signal
Signaling
Last Status Change
Last Mgmt Change
Number of SDPs
Hello Time
Hello Msg Len
Hello Timeout
Unmatched Replies
Max Drop Count
Hold Down Time
TX Hello Msgs
The SDP identifier.
Specifies the desired largest service frame size (in octets) that can be
transmitted through this SDP to the far-end router, without requiring
the packet to be fragmented.
Specifies the actual largest service frame size (in octets) that can be
transmitted through this SDP to the far-end router, without requiring
the packet to be fragmented.
Specifies the IP address of the remote end of the GRE or MPLS tunnel
defined by this SDP.
Specifies the desired state of the SDP.
Specifies the operating state of the SDP.
Specifies the type of delivery used by the SDP: GRE or MPLS.
Specifies all the conditions that affect the operating status of this SDP.
Specifies the signaling protocol used to obtain the ingress and egress
labels used in frames transmitted and received on the SDP.
Specifies the time of the most recent operating status change to this
SDP.
Specifies the time of the most recent management-initiated change to
this SDP.
Specifies the total number of SDPs displayed according to the criteria
specified.
Specifies how often the SDP Echo Request messages are transmitted
on this SDP.
Specifies the length of the SDP Echo Request messages transmitted on
this SDP.
Specifies the number of seconds to wait for an SDP echo response
message before declaring a timeout.
Specifies the number of SDP unmatched message replies timer
expired.
Specifies the maximum number of consecutive SDP Echo Request
messages that can be unacknowledged before the keepalive protocol
reports a fault.
Specifies the amount of time to wait before the keepalive operating
status is eligible to enter the alive state.
Specifies the number of SDP echo request messages transmitted since
the keepalive was administratively enabled or the counter was cleared.
Subscriber Services
Description
Page 103