Alcatel-Lucent 7750 SR OS Service Manual page 95

shutdown, causing the association with the SDP to be operationally down (the LSP will not be used
by the SDP).
LSP SDPs also require that the TLDP signaling is specified and the SDP Keepalive parameter must
be enabled and and not timed out.
Up to 16 LSP names can be entered on a single command line.
See MPLS Configuration Commands and RSVP Configuration Commands for CLI syntax and
command usage.
The no form of this command deletes one or more LSP associations from an SDP. If the lsp-name
does not exist as an association or as a configured LSP, no error is returned. An lsp-name must be
removed from all SDP associations before the lsp-name can be deleted from the system. The SDP
must be administratively disabled (shutdown) before the last lsp-name association with the SDP is
deleted.
Default
No LSPs names are defined.
Parameters
lsp-name — The name of the LSP to associate with the SDP. An LSP name is case sensitive and is
metric
Syntax metric metric
no metric
Context config>service>sdp
Description
This command specifies the metric to be used within the tunnel table manager for decision making
purposes. When multiple SDPs going to the same destination exist, this value is used as a tie-breaker
by tunnel table manager users such as MP-BGP to select the route with the lower value.
Parameters
metric — specifies the SDP metric.
signaling
Syntax signaling {off | tldp}
Context config>service>sdp
Description
This command specifies the signaling protocol used to obtain the ingress and egress labels in frames
transmitted and received on the SDP. When signaling is off then labels are manually configured when
the SDP is bound to a service. The signalling value can only be changed while the administrative
status of the SDP is down.
The no form of this command is not applicable. To modify the signaling configuration, the SDP must
be administratively shut down and then the signaling parameter can be modified and re-enabled.
Default
tldp
7750 SR OS Services Guide
limited to 32 ASCII 7-bit printable characters with no spaces. If an exact match of lsp-name does
not already exist as a defined LSP, an error message is generated. If the lsp-name does exist and
the LSP to IP address matches the SDP far-end IP address, the association is created.
Values
0 — 65535
Subscriber Services
Page 95