Alcatel-Lucent 7750 SR OS Service Manual page 154

Service router - mobile gateway
Hide thumbs Also See for 7750 SR OS:
Table of Contents

Advertisement

Configuring a VLL Service with CLI
Table 1: CLI Commands to Configure VLL Service Parameters (Continued)
Command
Configure Apipe SAP ATM parameters
config>service>apipe>sap# atm
atm
egress
traffic-desc
ingress
oam
alarm-cells
terminate
Configure Apipe spoke SDP parameters
config>service>apipe# spoke-sdp sdp-id:vc-id [no-endpoint]
config>service>apipe# spoke-sdp sdp-id:vc-id [endpoint endpoint-name] [icb]
cell-concatenation
aal5-frame-aware
clp-change
max-cells
max-delay
control-word
egress
ingress
precedence
vc-label
no shutdown
Configure an Fpipe service
Page 154
Enables access to the context to configure ATM-related attributes.
Configures egress ATM attributes for the SAP.
Assigns an ATM traffic descriptor profile to a given context (for
example a SAP).
Configures ingress ATM attributes for the SAP.
Enables the context to configure OAM functionality for a PVCC
delimiting a SAP.
Configures AIS/RDI fault management on a PVCC.
Specifies whether this SAP will act as an OAM termination point.
ATM SAPs can be configured to tunnel or terminate OAM cells.
Enables the context to provide access to the various options that
control the termination of ATM cell concatenation into an MPLS
frame. Several options can be configured simultaneously.
Enables the AAL5 end-of-message (EOM) to be an indication to
complete the cell concatenation operation.
Enables the CLP change to be an indication to complete the cell
concatenation operation.
Enables the configuration of the maximum number of ATM cells to
accumulate into an MPLS packet.
Enables the configuration of the maximum amount of time to wait
while performing ATM cell concatenation into an MPLS packet
before transmitting the MPLS packet.
Specifies whether the use of the control word is preferred or not.
Configures the egress spoke SDP context.
Configures the ingress spoke SDP context.
Specifies the precedence of this SDP bind when there are multiple
SDP binds attached to one service endpoint.
Configures the egress or ingress VC label.
Administratively enables the spoke SDP binding
Description
7750 SR OS Services Guide
Page
274
274
275
274
276
276
277
269
269
269
269
270
127
271
271
128
272
233

Advertisement

Table of Contents
loading

Table of Contents