Alcatel-Lucent 7750 SR OS Service Manual page 104

Global Service Configuration Commands
Sample Output
*A:ALA-12# show service sdp
==============================================================================
Services: Service Destination Points
==============================================================================
SdpId
------------------------------------------------------------------------------
10
40
60
100
500
------------------------------------------------------------------------------
Number of SDPs : 5
------------------------------------------------------------------------------
==============================================================================
*A:ALA-12#
*A:ALA-12# show service sdp 2 detail
===============================================================================
Service Destination Point (Sdp Id : 2) Details
===============================================================================
-------------------------------------------------------------------------------
-------------------------------------------------------------------------------
Description
SDP Id
Admin Path MTU
Far End
Admin State
Flags
Signaling
Last Status Change
Last Mgmt Change
KeepAlive Information :
Admin State
Hello Time
Hello Timeout
Max Drop Count
Tx Hello Msgs
Associated LSP LIST :
SDP Delivery Mechanism is not MPLS
===============================================================================
Page 104
Label
Rx Hello Msgs
Associated LSP
List
Adm MTU Opr MTU
4462 4462
4462 1534
4462 1514
4462 4462
4462 4462
Sdp Id 2 -(10.10.10.104)
: GRE-10.10.10.104
: 2
: 0
: 10.10.10.104
: Up
: SignalingSessDown TransportTunnDown
: TLDP
: 02/01/2007 09:11:39
: 02/01/2007 09:11:46
: Disabled
: 10
: 5
: 3
: 0
Specifies the number of SDP echo request messages received since the
keepalive was administratively enabled or the counter was cleared.
When the SDP type is MPLS, a list of LSPs used to reach the far-end
router displays. All the LSPs in the list must terminate at the IP address
specified in the Far End field.
If the SDP type is GRE, then the following message displays:
SDP Delivery Mechanism is not MPLS
IP address
10.20.1.3
10.20.1.20
10.20.1.21
180.0.0.2
10.20.1.50
7750 SR OS Services Guide
Description
Adm Opr Deliver Signal
Up Dn NotReady MPLS
Up Up MPLS
Up Up GRE
Down Down GRE
Up Dn NotReady GRE
Oper Path MTU : 0
Delivery : GRE
Oper State : Down
VLAN VC Etype : 0x8100
Adv. MTU Over. : No
Oper State : Disabled
Hello Msg Len : 0
Unmatched Replies : 0
Hold Down Time : 10
Rx Hello Msgs : 0
TLDP
TLDP
TLDP
TLDP
TLDP