Digisol DG-GS4826S Management Manual page 1073

u
u
E
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#lldp notification
Console(config-if)#
show lldp config
This command shows LLDP configuration settings for all ports.
S
YNTAX
C
OMMAND
Privileged Exec
E
XAMPLE
Console#show lldp config
LLDP Global Configuation
LLDP Port Configuration
SNMP trap destinations are defined using the
command.
Information about additional changes in LLDP neighbors that occur
between SNMP notifications is not transmitted. Only state changes that
exist at the time of a trap notification are included in the transmission.
An SNMP agent should therefore periodically check the value of
lldpStatsRemTableLastChangeTime to detect any lldpRemTablesChange
notification-events missed due to throttling or transmission loss.
show lldp config [detail interface]
detail - Shows configuration summary.
interface
ethernet unit/port
unit - Stack unit. (Range: 1-8)
port - Port number. (Range: 1-26/50)
port-channel channel-id (Range: 1-32)
M
ODE
LLDP Enable
LLDP Transmit interval
LLDP Hold Time Multiplier
LLDP Delay Interval
LLDP Reinit Delay
LLDP Notification Interval : 5
LLDP MED fast start counts : 4
Interface |AdminStatus NotificationEnabled
--------- + ----------- -------------------
Eth 1/1 | Tx-Rx
Eth 1/2 | Tx-Rx
Eth 1/3 | Tx-Rx
Eth 1/4 | Tx-Rx
– 1073 –
C
HAPTER
snmp-server host
: Yes
: 30
: 4
: 2
: 2
True
True
True
True
43 | LLDP Commands