Password Setting In P0000 - WEG CFW-11 Programming Manual

5.3 PASSWORD SETTING IN P0000

P0000 – Access to Parameters
Adjustable 0 to 9999
Range:
Properties:
Access groups 00 ALL PARAMETERS
via HMI:
In order to be able to change the content of the parameters, it is necessary to set correctly the password in
P0000, as indicated below. Otherwise the content of the parameters can only be visualized.
It is possible to customize the password by means of P0200. Refer to the description of this parameter in the
Section 5.4 HMI [30] on page
Seq. Action/Result
- Monitoring Mode.
- Press " Menu"
(right "soft key").
1
- The group "00 ALL
PARAMETERS" is already
selected.
2
- Press "Select".
- The parameter
"Access to Parameters
P0000: 0" is already
3
selected.
- Press "Select".
- In order to set the
password, press
until the number 5
4
appears on the display.
5-4, of this manual.
Display Indication
Ready 0rpm
LOC
0 rpm
0.0 A
0.0 Hz
15:45 Menu
Ready 0rpm
LOC
00 ALL PARAMETERS
01 PARAMETER GROUPS
02 ORIENTED START-UP
03 CHANGED PARAMETERS
Return 15:45 Select
Ready 0rpm
LOC
Access to Parameters
P0000: 0
Speed Reference
P0001: 90 rpm
Return 15:45 Select
Ready 0rpm
LOC
P0000
Access to Parameters
0
Return 15:45 Save
Figure 5.1 - Sequence for allowing parameter changes via P0000
Programming Basic Instructions
Seq. Action/Result
- When the number 5
appears, press "Save".
5
- If the setting was
performed correctly, the
display must show "Access
to Parameters P0000: 5".
6
- Press "Return"
(left "soft key").
- Press "Return".
7
- The display returns to the
Monitoring Mode.
8
Factory 0
Setting:
Display Indication
Ready 0rpm
LOC
P0000
Access to Parameters
5
Return 15:45 Save
Ready 0rpm
LOC
Access to Parameters
P0000: 5
Speed Reference
P0001: 90 rpm
Return 15:45 Select
Ready 0rpm
LOC
00 ALL PARAMETERS
01 PARAMETER GROUPS
02 ORIENTED START-UP
03 CHANGED PARAMETERS
Return 15:45 Select
Ready LOC 0rpm
0 rpm
0.0 A
0.0 Hz
15:45 Menu
5-3
5