Groups Accessed In The Option Menu In The Monitoring Mode; Password Setting In P0000 - WEG CFW-11 Programming Manual

Programming Basic Instructions

5.2 GRoUPS acceSSeD iN tHe oPtioN MeNU iN tHe MoNitoRiNG MoDe

In the monitoring mode access the groups of the option "Menu" by pressing the right "soft key".
Group
00 ALL PARAMETERS
01 PARAMETER GROUPS
02 ORIENTED START-UP
03 CHANGED PARAMETERS
04 BASIC APPLICATION
05 SELF-TUNING
06 BACKUP PARAMETERS
07 I/O CONFIGURATION
08 FAULT HISTORY
09 READ ONLY PARAMS.

5.3 PaSSWoRD SettiNG iN P0000

In order to be able to change the content of the parameters, it is necessary to set correctly the password in
P0000, as indicated below. Otherwise the content of the parameters can only be visualized.
It is possible to customize the password by means of P0200. Refer to the description of this parameter in the
section 5.4 of this manual.
Seq. Action/Result
- Monitoring Mode.
- Press " Menu"
5
(right "soft key").
1
- The group "00 ALL
PARAMETERS" is already
selected.
2
- Press "Select".
- The parameter
"Access to Parameters
P0000: 0" is already
3
selected.
- Press "Select".
- In order to set the
password, press
until the number 5 appears
4
on the display.
5-2
Table 5.2 - Parameter groups accessed in the option menu of the monitoring mode
All the parameters
Access to groups divided by functions
Parameter for entering the "Oriented Start-up" mode
Only parameters whose contents are different from the factory settings
Parameters for simple applications: ramps, minimum and maximum speed, maximum current and
torque boost. Presented in details in the CFW-11 User Manual at section 5.2.3
Access parameter (P0408) and estimated parameters
Parameters related to functions of parameter copy via FLASH Memory Module, keypad (HMI) and
software update
Groups related to digital and analog, inputs and outputs
Parameters with information on the 10 last faults
Parameters used only for reading
Display Indication
Ready
LOC
0 rpm
0.0 A
0.0 Hz
15:45
Ready LOC
00 ALL PARAMETERS
01 PARAMETER GROUPS
02 ORIENTED START-UP
03 CHANGED PARAMETERS
Return 15:45 Select
Ready LOC
Access to Parameters
P0000: 0
Speed Reference
P0001: 90 rpm
Return 15:45 Select
Ready
LOC
P0000
Access to Parameters
0
Return 15:45
Figure 5.1 - Sequence for allowing parameter changes via P0000
Contained parameters or groups
Seq. Action/Result
-When the number 5
0rpm
appears, press "Save".
5
Menu
- If the setting was
0rpm
performed correctly, the
display must show "Access
to Parameters
6
P0000: 5".
- Press "Return"
0rpm (left "soft key").
- Press "Return".
7
0rpm
- The display returns to the
Monitoring Mode.
Save
8
Display Indication
Ready LOC 0rpm
P0000
Access to Parameters
5
Return 15:45 Save
Ready LOC 0rpm
Access to Parameters
P0000: 5
Speed Reference
P0001: 90 rpm
Return 15:45 Select
Ready LOC 0rpm
00 ALL PARAMETERS
01 PARAMETER GROUPS
02 ORIENTED START-UP
03 CHANGED PARAMETERS
Return 15:45 Select
Ready 0rpm
LOC
0 rpm
0.0 A
0.0 Hz
15:45 Menu