Date And Time Setting - WEG CFW-11 Programming Manual

P0216 – HMI Display Contrast
Adjustable 0 to 37
Range:
Properties:
Access groups 01 PARAMETER GROUPS
via HMI:
Description:
It allows setting the keypad (HMI) display contrast level. Higher values configure a higher contrast level.

5.5 DATE AND TIME SETTING

Seq. Action/Result
- Monitoring Mode.
- Press "Menu"
1
(right "soft key").
- The group "00 ALL
PARAMETERS" is already
2 selected.
- The group "01
PARAMETER GROUPS" is
3 selected.
- Press "Select".
- A new list of groups is
showed on the display,
with the group "20
Ramps" selected.
4
- Press until
the group "30 HMI" is
selected.
- The group "30 HMI" is
selected.
5
- Press "Select".
30 HMI
Display Indication
Ready 0rpm
LOC
0 rpm
0.0 A
0.0 Hz
16:10 Menu
Ready 0rpm
LOC
00 ALL PARAMETERS
01 PARAMETER GROUPS
02 ORIENTED START-UP
03 CHANGED PARAMETERS
Return 16:10 Select
Ready 0rpm
LOC
00 ALL PARAMETERS
01 PARAMETER GROUPS
02 ORIENTED START-UP
03 CHANGED PARAMETERS
Return 16:10 Select
Ready 0rpm
LOC
20 Ramps
21 Speed References
22 Speed Limits
23 V/f Control
Return 16:10 Select
Ready LOC 0rpm
27 V/f DC Volt.Limit.
28 Dynamic Braking
29 Vector Control
30 HMI
Return 16:10 Select
Figure 5.2 - Date and time adjustment
Programming Basic Instructions
Seq. Action/Result
- The parameter "Day
P0194" is already
selected.
- If necessary, set P0194
according to the actual
day. Therefore, press
"Select".
- For changing P0194
6
contents or
.
- Proceed in the same
way for adjusting the
parameters from "Month
P0195" to "Seconds
P0199".
- When P0199 is finished,
the Real Time Clock will
7 be adjusted.
- Press "Return"
(left "soft key").
- Press "Return".
8
- Press "Return".
9
- The display returns to the
Monitoring Mode.
10
Factory 27
Setting:
Display Indication
Ready 0rpm
LOC
Day
P0194: 06
Month
P0195: 10
Return 16:10 Select
Ready 0rpm
LOC
Minutes
P0198: 11
Seconds
P0199: 34
Return 18:11 Select
Ready 0rpm
LOC
27 V/f DC Volt.Limit.
28 Dynamic Braking
29 Vector Control
30 HMI
Return 18:11 Select
Ready 0rpm
LOC
00 ALL PARAMETERS
01 PARAMETER GROUPS
02 ORIENTED START-UP
03 CHANGED PARAMETERS
Return 18:11 Select
Ready 0rpm
LOC
0 rpm
0.0 A
0.0 Hz
18:11 Menu
5-9
5