Pt100 Or Kty84 Temperature Sensor Type - WEG CFW-11 Programming Manual

15.4.2 PT100 or KTY84 Temperature Sensor Type

The parameters described in this section will be shown on the HMI when the IOE-02 or IOE 03 optional module
is connected into the slot 1 (XC41 connector). Refer to the
P0375 - Sensor 1 Fault/Alarm Temperature Setting
P0378 - Sensor 2 Fault/Alarm Temperature Setting
P0381 - Sensor 3 Fault/Alarm Temperature Setting
P0384 - Sensor 4 Fault/Alarm Temperature Setting
P0387 - Sensor 5 Fault/Alarm Temperature Setting
Adjustable -20 to 200 ºC
Range:
Properties: -
Access groups 01 PARAMETER GROUPS
via HMI:
Description:
These parameters allow adjusting the temperature for each sensor, at which temperature fault/alarm will occur.
P0388 - Sensor 1 Temperature
P0389 - Sensor 2 Temperature
P0390 - Sensor 3 Temperature
P0391 - Sensor 4 Temperature
P0392 - Sensor 5 Temperature
Description:
These parameters indicate, in Celsius degrees, the PT100 or KTY84 sensor temperatures.
P0393 - Highest Sensor Temperature
Adjustable -20 to 200 ºC
Range:
Properties: RO
Access groups 01 PARAMETER GROUPS
via HMI:
45 Protections
45 Protections
Figure 3.1 on page 3-2.
Factory
Setting:
Factory
Setting:
Faults and Alarms
130 ºC
-
15-21
15