Display Indications In The Monitoring Mode Settings - WEG CFW-11 Programming Manual

Programming Basic Instructions

5.6 DISPLAY INDICATIONS IN THE MONITORING MODE SETTINGS

Every time the inverter is powered the display goes to the Monitoring Mode. In order to make it easier the reading
of the motor main parameters, the keypad (HMI) display can be configured to show them in 3 different modes.
Content of the 3 parameters in numerical form:
Selection of the parameters via P0205, P0206 and P0207. That mode can be seen in the
Motor speed direction
indication.
Inverter indications:
- Run
- Ready
- Configuration
- Self tuning
- Last fault: FXXX
- Last alarm: AXXX
- DC Braking
- STO
Content of the 3 parameters in form of a bar graph:
Selection of the parameters via P0205, P0206 and/or P0207. The values are showed in percentage by means
of horizontal bars. This mode is illustrated in the
5
In order to configure the bar graph monitoring mode, access the parameters P0205, P0206 and/or P0207 and
select the options ended with the symbol "–" (values in the range from 11 to 20). Thus, the respective variable
is configured to be shown as a bar graph.
The Figure 5.5 on page
one variable to the graph mode.
5-10
Loc./Rem. indication
- LOC: Local situation.
- REM: Remote situation.
Run
LOC
1800
1.0
60.0
12:35
Left "soft key" function.
Indication of the time.
Adjusted in:
P0197, P0198 and P0199.
Figure 5.3 - Monitoring Mode screen at the factory setting
Run 1800rpm
LOC
rpm 100%
10%
A
Hz 100%
12:35 Menu
Figure 5.4 - Monitoring Mode screen with bar graphs
5-11, presented next, illustrates the procedure for the modification of the display of
Motor speed indication
in rpm.
Monitoring parameters:
- Motor speed in rpm.
- Motor current in Amps;
1800rpm
- Output frequency in Hz (default).
rpm
A
P0205, P0206 and P0207: selection of the
Hz
parameters to be shown in the Monitoring Mode.
Menu
P0208 to P0212: Engineering unit for the speed
indication.
Right "soft key" function.
Figure 5.4 on page 5-10.
Monitoring parameters:
- Motor speed in rpm.
- Motor current in Amps.
- Output frequency in Hz (default).
P0205, P0206 and P0207: selection of the parameters
to be shown in the Monitoring Mode.
P0208 to P0212: Engineering unit for the speed indication.
Figure 5.3 on page 5-10.