WEG CFW-11 Programming Manual page 295

Description:
Value obtained from the motor data sheet. If this information is not available, use the factory setting.
P0430 – PM Type
Adjustable 0 = Factory Setting
Range: 1 = Cooling Tower
Properties: CFG and PM
Access groups 01 PARAMETER GROUPS
via HMI:
Description:
When parameterized for standard Wmagnet motor (P0430 = 0), the parameterization of P0433, P0434 and
P0435 will be permitted. When P0430 = 1, the parameterization of P0442, P0443 and P0444 will be permitted.
P0431 – Number of Motor Pole
Adjustable 2 to 24
Range:
Properties: PM
Access groups 01 PARAMETER GROUPS
via HMI:
NOTE!
Set this parameter in 6 for the standard Wmagnet motor line (P0402 = 1800 rpm or 3600 rpm).
Other values are possible for special motors.
P0433 – Lq Inductance
P0434 – Ld Inductance
Adjustable 0 to 100.00 mH
Range:
Properties: PM
Access groups 01 PARAMETER GROUPS
via HMI:
43 Motor Data
43 Motor Data
43 Motor Data
PM Vector Control
Factory 0
Setting:
Factory 6
Setting:
Factory 0.00 mH
Setting:
21-7
21