Numerical Representation; Symbols For The Parameter Properties Description - WEG CFW-11 Programming Manual

kHz: kilohertz = 1000 Hz.
mA: milliamp = 0.001 Amp.
min: minute.
ms: millisecond = 0.001 second.
Nm: newton meter; torque measurement unit.
rms: "Root Mean Square"; effective value.
rpm: revolutions per minute: speed measurement unit.
s: second.
V: volt.
Ω: ohm.

2.2.2 Numerical Representation

The decimal numbers are represented by means of digits without suffix. Hexadecimal numbers are represented
with the letter "h" after the number.

2.2.3 Symbols for the Parameter Properties Description

RO Reading only parameter.
CFG Parameter that can be changed only with a stopped motor.
V/f Parameter visible on the keypad (HMI) only in the V/f mode: P0202 = 0, 1 or 2.
Adj Parameter visible on the keypad (HMI) only in the V/f adjustable mode: P0202 = 2.
Vector Parameter visible on the keypad (HMI) only in the vector modes with encoder or sensorless: P0202 = 3 or 4.
VVW Parameter visible on the keypad (HMI) only in the VVW mode: P0202 = 5.
Sless Parameter visible on the keypad (HMI) only in the vector sensorless mode: P0202 = 3.
Encoder Parameter visible on the keypad (HMI) only in the vector with encoder mode: P0202 = 4.
CFW-11M Parameter visible on the keypad (HMI) only when available in the Modular Drive.
PM Parameter visible on the HMI only in the control modes P0202 = 6 or 7.
General Information
2-3
2