Fault History [08] - WEG CFW-11 Programming Manual

Read Only Parameters [09]
Description:
They indicate the alarm (P0048) or fault (P0049) number that occasionally be present at the inverter.
In order to understand the meaning of the codes used for faults and alarms, refer to the
ALARMS on page 15-1
P0613 – Firmware Revision
Adjustable
Range:
Properties:
Access groups
via HMI:
Description:
It indicates the number of the inverter firmware version for Weg's internal control.
P0614 – PLD Revision
Adjustable
Range:
Properties:
Access groups
via HMI:
Description:
It indicates the number of the inverter PLD version for Weg's internal control.
P0692 – Operating Mode States
Adjustable
Range:
Properties:
Access groups
via HMI:
Description:
Parameter reserved for WEG.

16.1 FAULT HISTORY [08]

In this group are described the parameters that record the last faults occurred in the inverter, together with other
relevant information for the fault interpretation, as date, hour, motor speed, etc.
16
NOTE!
If the fault occurs simultaneously with the CFW-11 power up or reset, the parameters regarding this
fault, as date, hour, motor speed, etc., may contain invalid information.
16-10
in this manual and the Chapter 6 - Troubleshooting and Maintenance, of the user's manual.
-32768 to 32767
RO
09 READING PARAMETERS
-32768 to 32767
RO
09 READING PARAMETERS
0 to 65535
RO
09 READING PARAMETERS
Chapter 15 FAULTS AND
Factory 0
Setting:
Factory 0
Setting:
Factory 0
Setting: