Communication States And Commands - WEG CFW-11 Programming Manual

Communication [49]
P0757 – Profibus Writing Word #10
P0918 – Profibus Address
P0922 – Profibus Telegram Selection
P0944 – Fault Counter
P0947 – Fault Number
P0963 – Profibus Baud Rate
P0964 – Drive Identification
P0965– Profile Identification
P0967 – Control Word 1
P0968 – Status Word 1
Those are parameters for the configuration and operation of the Profibus DP interface. For a detailed description,
refer to the Profibus DP communication manual, available in www.weg.net.

17.5 COMMUNICATION STATES AND COMMANDS

P0313 – Communication Error Action
P0680 – Logical Status
P0681 – Motor Speed in 13 bits
P0692 – Operation Mode Status
P0693 – Operation Mode Commands
P0695 – Digital Output Setting
P0696 – Analog Outputs Value 1
P0697 – Analog Outputs Value 2
P0698 – Analog Outputs Value 3
P0699 – Analog Outputs Value 4
17
P0799 – I/O Update Delay
Those parameters are used for monitoring and controlling the CFW-11 inverter by means of communication
interfaces. For a detailed description, refer to the communication manual of the used interface. These manuals are
available in www.weg.net.
17-4