Attaching Clutch Cam Ass'y - TOHATSU TLDI MD 115A SERIES Service Manual

31) Attaching Clutch Cam Ass'y

Install clutch cam ass'y 1.
1.
Apply OBM grease to O ring of clutch cam
ass'y, and install the assembly by pushing cam
rod bushing into gear case.
Be careful of direction of clutch cam.
Attach stopper 2 and bolt 3.
2.
Attach O ring 2 to propeller shaft housing 1.
3.
Apply OBM grease to O ring.
Attach steel ball 4, clutch push rod 5 and washer 6 that
4.
was removed when disassembling to propeller shaft 3.
When gear case, propeller shaft or propeller
shaft housing is replaced, measure
propeller shaft play (forward direction) and
select thickness of washer 6 according to
the measurement.
Refer to Chapter 6, Section 3. Page 6-48
Install propeller shaft 3 to propeller shaft housing 1, and
5.
install the assembly to gear case.
· Install propeller shaft housing to gear case
securely, and tighten the securing bolts after
confirming that O ring is set in the case
properly.
· Apply ThreeBond 1342 to thread of propeller
shaft housing installation bolts.
Propeller Shaft Housing Bolts :
25 N · m (18 lb · ft) [2.5 kgf · m]
1342
1342 1342
TLDI 115A 2007
CAUTION
3
1
2
OBM OBM
OBM
3
6
2
1
OBM OBM
OBM
When bolts are reused
1342
1342
3 O Ring
Do not reuse.
Forward
Direction
6
5
4
6-37