Disassembling Bracket Unit And Assembling The Parts; Trim Cylinder, And Assembly Of The Parts - TOHATSU TLDI MD 115A SERIES Service Manual

Cowl, Bracket and PTT
21) Disassembling Bracket Unit and
Assembling the Parts
Remove manual valve 1.
1.
2. Attach a new O ring to down relief valve.
Attach filter 2 to down relief valve 3, and put the filter
3.
assembly in the gear pump.
Attach new O ring 4 to manual valve.
4.
5. Install manual valve to gear pump and secure it with "C"
ring 5.
Manual Valve :
3 N · m (2.2 lb · ft) [0.3 kgf · m]
22) Disassembly of Tilt Cylinder and Trim
Cylinder, and Assembly of the Parts
Loosen and remove tilt cylinder rod guide 3 by using trim
1.
rod guide wrench 1 and remove tilt piston ass'y.
When removing tilt cylinder rod guide, fully
extend trim rods and tilt arm.
2. Drain PTT fluid.
Trim Rod Guide Wrench 1 :
P/N. 3C8-72791
Loosen and remove trim cylinder rod guide 4 by using
3.
trim rod guide wrench 2 and remove trim piston ass'y.
Trim Rod Guide Wrench 2 :
P/N. 3B7-72792
4. Drain PTT fluid.
5. Install piston ass'y and temporary tighten trim cylinder rod
guide.
7-36
CAUTION
4
2
3
3
4
1
5
1
2
TLDI 115A 2007