Disassembly Of Propeller Shaft Housing Ass'y - TOHATSU TLDI MD 115A SERIES Service Manual

Lower Unit
9) Disassembly of Propeller Shaft
Housing Ass'y
1. Pull out propeller shaft ass'y 1.
2. Remove reverse (C) gear by using
Remove bearing 4.
3.
Heat propeller shaft housing by putting it in
the hot water of approximately 60 - 70˚C
(140 - 158˚F), and remove bearing 4.
Be careful not to burn.
Heating of propshaft housing can also be made
by using a heat gun or heat lamp.
4. Use a press to remove oil seal 5 and needle bearing 6 at
the same time.
Before removing, check bearing for play or
deflection. Replace if necessary.
Needle Bearing Attachment 7 :
P/N. 3T1-99710-0
Driver Rod 8 :
P/N. 3AC-99702-0
Center Plate 9 :
P/N. 3AC-99701-0
This work can be done also by using the following tool kit.
Needle Bearing Puller Kit 7 :
P/N. 3B7-72700-0
5. When removing only oil seal, use bladed screw driver to
pry apart.
6-14
−
screw drivers 3.
CAUTION
CAUTION
4
4 Bearing
Do not reuse.
8
7
5 Oil Seal
Do not reuse.
6 Needle Bearing
Do not reuse.
1
3
2
9
6
5
TLDI 115A 2007