Electrical Wiring Assembling Instruction Diagram -2 - TOHATSU TLDI MD 115A SERIES Service Manual

Electrical Wiring Assembling Instruction Diagram -2

Ground lead of cord ass'y
Ground boss of air chamber
Starter Cable
(Ground Lead)
A
Run FFP and CPS cords through
crank case hose to the other side
of oil tank, and fix them to FFP clamp.
Y L
Y L
- +
- +
VIEW "A"
Clamp, 6.5-47.5P
Fix alternator cord by using
the clamp that is tightened
together to upper side of
Attach ground lead.
vapor separator installation bolt.
Fix rectifier ground leads to
installation bolts on the
upper side of #2 and #3
ignition coils.
Fix vapor separator ø2 hose to
starter motor B/K using hose tie.
Run the cord through the other
side of coupler.
Attach ground lead.
Fix alternator cord to fuel
hose by using clamp.
TLDI 115A 2007
Secure the ground wire of cord ass'y
with #1 ignition coil upper securing bolt.
Run earth lead of each ignition coil
through the other side of high tension
cord and fix with installation bolt located
on the lower side of ignition coils.
Fix cord ass'y to air rail
by using stay and band.
11-8