Operating System; Adjustment Of Throttle Cable - TOHATSU TLDI MD 115A SERIES Service Manual

Inspections and Adjustments

7. Operating System

1) Adjustment of Throttle Cable

Loosen lock nut 1.
1.
Remove "R" shaped pin 2 and washer 3.
2.
Remove cable joint 4 from advancer arm 5.
3.
Bring advancer arm 5 to full close stopper 6.
4.
Set remove control lever to throttle full close position 7.
5.
6. Adjust cable joint screw-in length so that the pin of
advancer arm is aligned with the hole of cable joint 4.
Adjust cable joint screw-in length a to
10mm (0.39in) or over.
Adjust the cable joint so that advancer arm
pushes the full close stopper a little.
7. Attach cable joint, washer and "R" shaped pin to advancer
arm.
8. Check if throttle control can be made smoothly. If
necessary, readjust by following the steps 1 to 7.
Make sure the cable pushes the throttle arm against the
stop at WOT in forward against.
TPS error occurs if advancer arm touches
the full close stopper when remote control
lever is at throttle full close position.
Refer to Chapter "10" for resetting the
error.
3-18
CAUTION
CAUTION
2
3
a
6
5
1
4
N
7
N
TLDI 115A 2007