12) Disassembly of Propeller Shaft
Ass'y
Remove push rod 1 and steel ball 2.
1.
Put a bladed screw driver into one of clutch pin snap 3
2.
end, and take the snap out from the clutch groove while
winding it.
Pull out clutch pin 4, and remove clutch spring retainer
3.
5, clutch spring 6, and clutch by referring to the figure.
When removing clutch pin, wear protective
glasses, and do not point opening of
propeller shaft to your face or body while
holding the propeller shaft. Clutch pin or
spring holder may fly out very quickly.
Install push rod 1, and pull out pin 4 while
pushing propeller shaft onto a plane to
prevent retainer 5 and spring 6 from flying
out.
After taking out clutch spring retainer 5 and clutch spring
4.
6, remove clutch 7 from propeller shaft.
TLDI 115A 2007
WARNING
3
7
6
5
2
1
4
3 Clutch Pin Snap
Do not reuse.
3 Clutch Pin Snap
Do not reuse.
7
3
4
6
1
6-19