Assembly Of Drive Shaft Housing Parts - TOHATSU TLDI MD 115A SERIES Service Manual

Cowl, Bracket and PTT
5. Check that drive shaft housing is provided with two holes
on the area opposite to reverse gas pipe installation face.
The drive shaft housing of model 115 is provided
with two holes.

8) Assembly of Drive Shaft Housing Parts

Install exhaust pipe 1 and gasket 2 to engine base 3
1.
and tighten bolts 8 to specified torque.
Exhaust Pipe Bolts 8 :
20 N · m (14 lb · ft) [2.0 kgf · m]
Install exhaust housing grommet 4 to exhaust housing
2.
5.
When installing the grommet by using adhesive,
clean adhering area to remove dirt and oil and
dry the area before applying adhesive.
Install exhaust housing 5 and gasket 6 to engine base
3.
3 and tighten bolts 9 to specified torque.
Exhaust Housing Bolts 9 :
15 N · m (11 lb · ft) [1.5 kgf · m]
7-20
60 mm 60 mm
(2.362 in) (2.362 in)
(0.394 in)
20 mm 20 mm
(0.788 in) (0.788 in)
1
8
2
3
4
1741 1741
5
1741 1741
9
6
7
TLDI 115A 2007
ø10 mm