Air Bleeding - TOHATSU TLDI MD 115A SERIES Service Manual

15) Air Bleeding

1. Visually check if any air is found in the oil line from oil tank
to cylinder block, and if any air is found, bleed the air by
using the following procedure.
2. Fill oil tank.
3. Disconnect oil filter inlet hose, and then reconnect the
hose when oil containing no air bubble flows out.
Then loosen nut on top of oil-filter and pull assembly away
from the down head.
Pull outlet hose off and turn filter on its side(inlet,outlet
facing up)and allow all air to escape from filter,then return
to normal position and slide outlet line black on filter.
Put the drained oil in a container to
prevent it from spreading on the engine.
Set key switch 1 to "ON".
4.
Pull off lock plate 3 within one second from the moment
5
warning buzzer 2 stops.
Pull stop switch 4 twice within two seconds.
6.
When the above operation is performed exactly,
the buzzer pips three times and oil pump starts
to run. If the buzzer does not pips three times,
set the key switch to "OFF" and repeat the
above steps.
7. The oil pump continues to operate to feed oil. When air is
bled from the oil, set the key switch to "OFF".
The oil pump stops automatically at approximately
one minute.
TLDI 115A 2007
CAUTION
1
N
FF START
1
4
2
4
3
2
3
4-47