TOHATSU TLDI MD 115A SERIES Service Manual page 45

Applied to
Air Injector O Ring
Air Injector Terminal
Fuel Injector O Ring
Fuel Injector Terminal
Fuel Regulator O Ring
Air Regulator O Ring
Compression Seal
Plug O Ring
Air Hose L Nipple O Ring
Fuel Hose L Nipple O Ring
Valve Ass'y
Piston
Cylinder
Piston Pin
Piston Ring
Big End Needle Bearing
Housing Oil Seal
Crank Shaft B/G
Collar O Ring
Adapter Hose Joint
Adapter Hose Joint
Cable Terminal Grommet
FFP Upper Grommet
FFP Lower Grommet
Pipe Grommet
TLDI 115A 2007
Konish Three
ThreeBond Loctite Chuo Yuka
i Bond
Centax
1342 1373B 518 G17 1741 FM-531
L2
○
○
○
○
Shinetsu
Silicones
ATF
KS-64
(*1)
○
Apply to two O Rings.
○
Terminal section
○
Apply to two O Rings.
○
Terminal section
○
Apply to two O Rings.
○
Apply to two O Rings.
○
Apply to 6 locations in the air rail.
○
Apply to 3 locations in the air rail.
○
Apply to two O Rings.
○
Apply to two O Rings.
Apply to tapered screw section.
○
Apply to whole circumference.
○
Apply to whole circumference.
○
Apply to whole circumference.
○
Apply to whole circumference.
○
Apply to rolling sections.
Fill lip area.
○
Apply to rolling sections.
○
Apply to rolling sections.
Apply to embededed sections (M10P1.0
sections).
Apply to embededed sections (M10P1.0
sections).
○
Apply to both inner and outer faces.
○
Apply to both inner and outer faces.
○
Apply to both inner and outer faces.
○
Apply to both inner and outer faces.
Remarks
2-19
2