Lower Unit
33) Measurement of Pinion (B) Gear
Height and Shim Selection
1.
Before measuring back lash of each gear, measure drive
shaft pinion (B) gear height and adjust the height to proper
value if necessary.
In accordance with procedure described in "Assembly of
Lower Unit" in Chapter 6, install the parts up to pump case
1, and secure it by using M8 bolt (L=35mm) and flat
washer 3.
M8 Bolt (L=35mm) + Flat Washer 3 :
13N · m (9.0 lb · ft) [1.3kgf · m]
6-40
3
2
3
1
TLDI 115A 2007