Assembling Crank Case Halves - TOHATSU TLDI MD 115A SERIES Service Manual

Power Unit

22) Assembling Crank Case Halves

1. Degrease crank case and cylinder mating faces.
2. Apply sealing agent to crank case's mating surface.
Crank Case Mating Surface :
Loctite #518
518 518
Be careful not to allow sealing agent to squeeze
out.
Apply sealing agent on the area inside of the
bolt holes continuously in width of approximately
1 mm as shown.
3. When installing crank case, check position of dowel pins
a.
5-46
518
518
a
a
TLDI 115A 2007