TOHATSU TLDI MD 115A SERIES Service Manual page 41

Functional Limit
When parts are worn or damaged
When parts no longer conform to standard values
When parts no longer conform to standard values
When parts are worn or damaged
When parts show deterioration or contamination by fuel
When parts are worn or damaged
When parts are worn, damaged or stretched out of shape
When parts no longer conform to standard values
1) 0.9mm (0.036 in)
2) When electrodes show excessive wear
When parts no longer conform to standard values
No clicking sound when 12 volts is applied to the terminal
When parts no longer conform to standard values
When parts are worn or damaged
No clicking sound when 12 volts is applied to the terminal
When parts no longer conform to standard values
When the resistance value between upper and lower connectors
∞Ω or 0Ω
When the resistance value between upper and middle connectors
becomes erratic
When parts no longer conform to standard values
When parts no longer conform to standard values
When parts no longer conform to standard values
When parts no longer conform to standard values
When parts no longer conform to standard values
12 mm (0.47 in)
0.2 mm (0.008 in)
32 mm (1.26 in)
When the fuse burns out
When parts no longer conform to standard values
When parts no longer conform to standard values
TLDI 115A 2007
Action To Be Taken
Replace with new part.
Replace with new part.
Replace with new part.
Replace with new part.
Replace with new part.
Replace with new part.
Replace with new part.
Repair so that parts conform to standard values.
Replace with new part.
Replace with new part.
Replace with new part.
Replace with new part.
Repair so that parts conform to standard values.
Replace with new part.
Replace with new part.
Replace with new part.
Replace with new part.
Replace with new part.
Replace with new part.
Replace if less than specified limit.
Replace with new part.
After repairing the cause of the burn-out, replace with a new fuse.
Replace with new part.
Replace with new part.
2
2-15