TOHATSU TLDI MD 115A SERIES Service Manual page 265

Put PTT fluid in the tilt cylinder through hole a to a proper
9.
level.
Install tilt piston to cylinder, and tighten tilt rod guide 5 to
10.
specified torque.
When installing, check that tilt rod is fully
extended.
After installing tilt piston, do not push tilt
rod. Doing so will cause fluid to spurt.
Tilt Rod Guide 5 :
130 N · m (94 lb · ft) [13.0 kgf · m]
Trim Rod Guide Wrench 1 :
P/N. 3C8-72791
Attach joint 2 and gear pump filter 3 to gear pump.
11.
12. Fill gear pump with PTT oil to a proper level.
TLDI 115A 2007
CAUTION
a
5
2
3
1
7
7-39