TOHATSU TLDI MD 115A SERIES Service Manual page 217

Connect shift rod joint 1 and shift rod 2, and drive in
5.
spring pin 3.
Spring Pin Tool B 4 :
P/N. 369-72218-0
Do not reuse spring pin.
Replace with new one when removed.
Attach propeller and tighten propeller nut 2 to specified
6.
torque.
Propeller Nut 2 :
12N · m (9 lb · ft) [1.2kgf · m]
Attach split pin 3.
7.
If propeller shaft pin hole and propeller nut
pin groove do not align, additionally tighten
the nut until they align.
8. Fill gear case with gear oil to specified level.
Refer to "Replacement of Gear Oil" in Chapter 3.
Perform "Inspection of Gear Case (Air
Leakage)" in Chapter 3 if necessary.
· Before removing or installing propeller, be
sure to disconnect battery cables from
battery and remove stop switch lock
plate.
· When removing or installing propeller, do
not handle propeller with bare hands.
· Put a piece of wooden block between
anti-ventilation plate and propeller to
prevent rotation of propeller when
removing or installing propeller.
TLDI 115A 2007
CAUTION
CAUTION
2
1
3 Spring Pin
Do not reuse.
OBM OBM
OBM
12 N·m (9 lb·ft) [1.2 kgf·m]
3 Split Pin
Do not reuse.
3
4
3
1 2
6
6-39