Removing Air Compressor; Removing Drive Belt - TOHATSU TLDI MD 115A SERIES Service Manual

Fuel System (TLDI)

7. Removing Air Compressor

1) Removing Drive Belt

1. Mark drive belt with an arrow as shown to indicate
orientation.
When reusing the drive belt, install it in its
original orientation indicated by the arrow.
2. Loosen compressor mounting bolts and slide the
compressor to crank case side.
3. Move the belt upward to remove.
The belt can be made slack when it is slid
because it is located with two knocks.
If the belt cannot be removed by using the
above method, remove the bolt and then
remove the belt while turning pulley of the air
compressor.
2) Removing Air Compressor
Remove compressor by using the following steps.
Loose the clamps of oil pipe 1, Recirculation pipe 2 and
1.
cooling water pipe 3 at compressor side and pull hoses
out.
Loosen nut of high pressure air hose 4 and disconnect
2.
the hose.
Remove bolts 5 and remove the compressor.
3.
If performing the work after stopping the engine,
do it after cooling the high pressure hose
because it is made hot during the operation.
4-36
CAUTION
6
3
5
4
2
7
1
TLDI 115A 2007