TOHATSU TLDI MD 115A SERIES Service Manual page 59

Inspections and Adjustments
Inspection of Water Pump
1. Remove the following part.
Drive out spring pin 1 by using spring pin tool 2.
Spring Pin Tool A 2:
P/N. 369-72217-0
● Remove gear case ass'y from drive shaft housing.
2. Remove the following parts.
3 Gear Case Plate (One M10 bolt is behind the plate.)
4 Bolts : M8 4 pcs.
5 Bolts : M10 2 pcs.
6 Gear Case Ass'y (Pull downward to remove.)
Speed meter pipe is put on the nipple of gear
case ass'y. After gear case has come down
slightly, remove pipe from nipple.
3. Check following parts.
7 Bolts : M8
4 pcs.
8 Washers
4 pcs.
9 Pump Case (Upper)
0 Pump Case Liner
q Pump Impeller ➝ Replace with new one.
w Key
➝ Replace with new one.
e Seal
r Guide Plate
➝ Replace with new one.
t Gasket
y Dowel Pin
u Pump Case (Lower)
i O Ring
o Oil Seals
p Shim
Inspection
6 - t : Replace with new one if worn or damaged.
1.
o Be sure to install oil seal in correct orientation.
3-12
2
1
Do not reuse.
5
3
6
7
8
9
0
w
u
i
qtio
Do not reuse.
1
6
4
q
e
r
t
y
o
p
o
TLDI 115A 2007