TOHATSU TLDI MD 115A SERIES Service Manual page 266

Cowl, Bracket and PTT
13. Remove air bubbles by using a means such as a syringe.
Install O ring 4 and power trim and tilt motor ass'y 5, and
14.
tighten bolts 6 to specified torque.
Engage armature shaft joint groove with
the shaft of pump.
Tilt Motor Ass'y Installation Bolts 6 :
4 N · m (3 lb · ft) [0.4 kgf · m]
15. Remove reservoir cap and check PTT fluid level.
The fluid quantity is acceptable if the fluid
level is at the top of the filter hole.
16. Add fluid until filter hole is filled if necessary.
Tighten reservoir cap 7 to specified torque.
17.
Reservoir Cap :
7 N · m (5 lb · ft) [0.7 kgf · m]
18. Purge air from power trim and tilt unit.
19. Check hydraulic pressure of power trim and tilt unit.
7-40
CAUTION
CAUTION
7
6
5
4
TLDI 115A 2007