TOHATSU TLDI MD 115A SERIES Service Manual page 264

Cowl, Bracket and PTT
Fill with PTT fluid from b, c, and d to a proper level.
3.
4. Install trim piston ass'y to trim cylinder, and tighten trim rod
guide 2 to specified torque.
When installing, check that trim rods are
fully extended.
After installing trim piston ass'y, do not
push trim rod. Doing so will cause fluid to
spurt.
Trim Rod Guide 2 :
80 N · m (58 lb · ft) [8.0 kgf · m]
Trim Rod Guide Wrench 1 :
P/N. 3C8-72792
5. Attach new O ring, valve pin and valve seat ass'y to tilt
cylinder.
6. Install gear pump 3.
Gear Pump Installation Bolts :
9 N · m (7 lb · ft) [0.9 kgf · m]
7. Put O ring on the reservoir cap.
Install reservoir 4, and put O ring on the gear pump.
8.
Reservoir Mount Bolts :
5 N · m (4 lb · ft) [0.5 kgf · m]
7-38
CAUTION
b
d
2
4 4
c
1
3
TLDI 115A 2007