Disassembly Of Drive Shaft Housing - TOHATSU TLDI MD 115A SERIES Service Manual

6) Disassembly of Drive Shaft Housing

1. Remove bolts that secure engine base to drive shaft
housing.
Remove M6 installation bolt located in the area
shown by the arrow.
2. Tap lightly with a plastic hammer to separate engine base
from the housing if it is seized.
If necessary, use a bladed screw driver to pry
the engine base taking care not to scratch
mating surface.
When removing drive shaft housing 3, be careful not to
3.
lose dowel pin 4 for locating engine base 2.
TLDI 115A 2007
1
3
4
4
2
7
2
3
7-17