Outboard Motor Installation Template - TOHATSU TLDI MD 115A SERIES Service Manual

Do not drill upper mounding holes on the area of the
transom below 25.4 mm (1 in) or lower from the top edge
of the transom.
Ø13.0 mm hole
(0.51 in)
WARNING
When securing an outboard motor on
the transom, upper installation bolts with
washer should be run from inside of the
hull to outside, and lower installation
bolts should be run from outside of the
hull to inside, and the bolts are to be
tightened using a washer and nut. After
installing an outboard motor, check the
installation for water-tightness and that
the outboard is fixed on the transom
securely.
Installation of an outboard motor
improperly bolted on the transom can
cause damages to the hull, submersion
of the machine, and/or injury to the
crew(s) and passenger(s).
WARNING
163.5 mm
(6.44 in)
125.5 mm
(4.94 in)
Upper edge of transom
163.5 mm
(6.44 in)

Outboard Motor Installation Template

Vertical center line of boat transom
125.5 mm
(4.94 in)