Assembly Of Gear Case Parts - TOHATSU TLDI MD 115A SERIES Service Manual

Lower Unit

29) Assembly of Gear Case Parts

Use the following tools to install taper roller bearing 1
1.
outer race.
Bearing Outer Press Kit :
P/N. 3B7-72739-0
Bearing Outer Press Plate 2 :
P/N. 3B7-72732-0
Bearing Outer Press Guide 3 :
P/N. 3B7-72733-0
Bearing Outer Press Rod 4 :
P/N. 3B7-72731-0
Nut M10 5 :
P/N. 930191-1000
Spring Washer 6 :
P/N. 941392-1000
2. Fix gear case on a holder with its propeller shaft opening
facing upward.
3. Clean outer race installation face in the gear case and
apply gear oil.
3. Apply gear oil to external face of outer race, and put the
outer race in the center of the housing with the marked
face of the race facing in the housing.
Put rod ass'y into gear case slowly so that plate 2
4.
contacts inside of the outer race, and put the guide on the
rod and set it in the opening of the gear case.
5. Tap the end of the rod with a hammer to press-fit the outer
race in the housing securely.
The hammering sound changes when the outer
race is set in the housing properly.
6-32
2
6
5
1
4
3
GEAR GEAR
GEAR
2
1
4
2
3
3
4
56
TLDI 115A 2007