Assembly Of Propeller Shaft Housing - TOHATSU TLDI MD 115A SERIES Service Manual

Lower Unit
11) Assembly of Propeller Shaft
Housing
Use a press to push new needle bearing 4 into propeller
1.
shaft bearing to specified depth.
· Install needle bearing with the manufacturer's
a facing the tool side.
mark
· Screw in needle bearing attachment 2 lightly
by a hand so that no gap is made at driver rod
1.
· Clean needle bearing installation face and
apply gear oil before installation.
Driver Rod 1 :
P/N. 3AC-99702-0
Needle Bearing Attachment 2 :
P/N. 3U1-99710-0
Center Plate 3 :
P/N. 3AC-99701-0
Depth of Installation b :
87.25 - 87.75 mm (3.435 - 3.455 in)
This work can be done also by using the following tool kit.
Needle Bearing Puller Kit 7 :
P/N. 3B7-72700-0
6-16
1
3
b
2
4 Needle Bearing
Do not reuse.
a
5
GEAR GEAR
GEAR
4
TLDI 115A 2007