Inspection Of Drive Shaft; Assembly Of Drive Shaft Parts - TOHATSU TLDI MD 115A SERIES Service Manual

Lower Unit

24) Inspection of Drive Shaft

1. Check drive shaft for bend and wear.
Replace if necessary.
2. Measure drive shaft runout.
Runout Limit :
0.3 mm (0.012 in)

25) Assembly of Drive Shaft Parts

Attach pinion (B) gear nut 1 to drive shaft temporarily.
1.
Install bearing 1 by using press.
2.
Before installing bearing, be sure to clean drive shaft
installation face and apply gear oil.
Bearing Install Tool 2 :
P/N. 3T1-99900-0
Do not press drive shaft thread a directly.
Put a piece of protector (steel plate) on the
tip of the shaft.
Refer to "Chapter 6 Shim Adjustment".
A nut that fits the thread can be used to protect
the shaft tip when pressing.
Install taper roller bearing 3 by using press.
3.
Bearing Install Tool 2 :
P/N. 3T1-99900-0
Do not press drive shaft thread a directly.
Put a piece of protector (steel plate) on the
tip of the shaft.
Before installing taper roller bearing, be sure to clean drive
shaft installation face and apply gear oil.
6-28
CAUTION
CAUTION
a
a Supporting Points
a
1 Bearing
Do not reuse.
a
3 Taper Roller Bearing
Do not reuse.
a
1
2
GEAR GEAR
GEAR
3
GEAR GEAR
GEAR
TLDI 115A 2007