Air Bleeding - TOHATSU TLDI MD 115A SERIES Service Manual

3) Air Bleeding

1. Visually check if any air is found in the oil line from oil tank
to cylinder block, and if any air is found, bleed the air by
using the following procedure.
2. Fill oil tank.
3. Disconnect oil filter inlet hose, and then reconnect the
hose when oil containing no air bubbles flows out.
Put the drained oil in a vessel to prevent it
from spreading on the machine.
Set key switch 1 a to "ON".
4.
Pull off lock plate 3 within one second from the moment
5
warning buzzer 2 stops.
Pull stop switch 4 twice within two seconds.
6.
When the above operation is completed, the
buzzer sounds three times and oil pump starts
to run. If the buzzer does not sounds three
times, set the key switch to "OFF" and repeat
the above steps.
7. The oil pump continues to operate to feed oil. When air is
bled from the oil, set the key switch to "OFF".
The oil pump stops automatically at approximately
one minute.
TLDI 115A 2007
CAUTION
1
ON
START
OFF
1
4
3
2
3
2
3
3-5