Disassembly Of Forward Gear (A) Gear; Inspection Of Forward (A) Gear - TOHATSU TLDI MD 115A SERIES Service Manual

Lower Unit
19) Disassembly of Forward Gear (A)
Gear
Remove taper roller bearing 1.
1.
Use two bladed screw drivers to remove taper roller
bearing from forward gear (A) gear.
Put the drivers into grooves of forward (A) gear, and pry
out taking care not to damage the shim.
Be careful not to damage shim 3.
Remove needle bearing 4.
2.
Drive out needle bearing from the gear by using a bladed
screw driver or a punch and a hammer at teeth side of the
gear.
When removing needle bearing, take care
not to scratch forward (A) gear bearing
face.
Do not reuse removed needle bearing.

20) Inspection of Forward (A) Gear

1. Check forward (A) gear teeth and clutch claws for crack,
damage and wear.
Replace if necessary.
6-24
CAUTION
CAUTION
CAUTION
4
4
4 Needle Bearing
Do not reuse.
1
3
TLDI 115A 2007