Power Unit
5) Removing Throttle Link
Remove throttle link rod 1 and TPS link rod 2.
1.
Remove each link rod at the advancer arm side
3 first.
When removing each link rod at the ball joint
side, be careful not to apply force to the arm.
2.
Remove throttle position sensor's lower mounting screw.
That is rubber mounted.
Remove only as an assembly.
Do not remove the two-philips screws q
(with yellow paint that hold sensors
together.)
3.
Loosen advancer arm mounting bolt and remove the arm.
Check ball joint cap for wear and damage link
rod for bend.
Throttle Link Rod Snap 9
Rod Snap 0
Check link rod snap for wear and damage.
5-24
WARNING
3
1
9
4
2
5
6
0
1
2
q
7
8 5
3
TLDI 115A 2007